[DayvG]

Hi @Vithy,

Are you able to send commands to your car? 
Horn, Locate vehicle, Lock unlock?
 
I have done the esim swap, i have online services all works fine, but dont have remote services . 
i'm not able to have the remote commands working or am I able to locate my vehicle

The esim ICCID match but the Modem IMEI does not 

Just wanted to give an update.
Anyone going from 3G TCB to 4G ATM and have done the eSIM swap. All we needed to do in the case of Timbits93. Just code the ATM to 3G PROD. Since the SIM is provisioned for just 3G , it wouldn't work on the 4G network. At least that's the theory.

Once FDL coding is done on ATM, must force update provisioning_ecall using Tool32 and NBT EVO (Using the GUI) That  should allow you the get the location/other functions. After ATM FDL coding make sure you reboot the EVO and enable location tracking on IDRIVE.

I've retrofitted an EVO and ATM to a F25, replacing the NBT and ATM. Also did an eSIM swap from TCB 3G to ATM 4G.

However, when I run update online services, immediately it runs into "A fault occurred when writing the parameters to the control unit" and also shows no back end connection.

I had flashed the ATM so the original VIN was written, which also matches the NBT EVO.

ICC ID matches the original eSIM, and sim card status shows as logged in and roaming, as well as mobile network connection was established no problem.

Do I need to contact ConnectedDrive to force update online services from their back end so it can sync back up, or is there something missing on my end that's causing a fault to occur when it's trying to write the parameters to the ATM?

Have you added the car again to connected drive? And received the code in the car?