[NTec]

Hi everyone,

I need some help modifying a file for an їvёc0 truck.

The vehicle has recently undergone an engine swap where the original engine was replaced with a more powerful 280HP variant. However, due to CAN Bus / vehicle networking compatibility issues with the newer donor ECU (which completely blocks the pneumatic system and chasis VCM), I am strictly keeping the truck's original 2002 Engine ECU and software base.

To make the most out of the new engine block without triggering any network conflicts, I want to upgrade/remap the original file to match the physical engine performance.
ECU Details:

• Hardware: B05cн EDC7C1 - 0 281 010 253 (їvёc0 4898111)
  
• Software Version: P_1684.1.2 (Original 2002 baseline file)
  

Could someone help me with a proper Stage 1 / optimization built specifically over this software skeleton so the engine performs correctly with the new displacement/power setup while keeping all chasis features active?

full bdm ori ktag.zip
File Type:
Downloaded:	1 times
Size:	354.97 KB

Thank you very much in advance!