[PUMUKY1]

Ok, thanks a lot. I have a question. I don't fully understand post #4. If I have a JBE, which pin is (+) and which is GND?

Black 47-pin connector A34*1B - Pin 23 Ground

The 23-pin connector +12V - Pins 3, 5, 6, 7, 21, 22, 23

[jansmerfowski]

''Junction Box
Connector 2B
Pins:
1——-KCan high bus connection to Zgw and junction box
2——-KCan low bus connection to Zgw and Junction box
5—-loop terminator junction box 2B pin 42
6—- loop terminator junction box 2B pin 43''

I don't understand this connection exactly.
Should I put a jumper between pins 5 and 42 in plug 2b?

And also a jumper between pins 6 and 43 in plug 2b?

[PUMUKY1]

This is JBE's PinOut

JBBFE III V2
Blue Connector 54 poles A34*2B

* Jumper Pins 5 and 42
* Jumper Pins 6 and 43
* Pin 1 I/A K-CAN2_H yellow/red BUS connection - ZGM Pin 48 I/A K_CAN2_H
* Pin 2 E/A K-CAN2_L yellow/brown BUS connection - ZGM Pin 49 E/A K_CAN2_L

CAS4
A16*2B 26 poles white

* Pin 11 A Relay activation terminal 30B - JBE A34*3B Pin 23 E Relay activation terminal 30B
* Pin 24 A Relay activation terminal 15N - JBE A34*3B Pin 41 E Relay activation terminal 15N

[jansmerfowski]

Thanks. Now everything is clear.

[jansmerfowski]

Hello. I have one last question, if you can help. It's about the Cas4 Connector 2B?

7————ignition switch pin 9

9————ignition switch pin 9

Two pins from the CAS module to one pin from the START button?

Is this the correct connection?

[PUMUKY1]

Hello. I have one last question, if you can help. It's about the Cas4 Connector 2B?

7————ignition switch pin 9

9————ignition switch pin 9

Two pins from the CAS module to one pin from the START button?

Is this the correct connection?

This is the connection for Pins 7 and 9

CAS4 A16*2B Pin 7 - Start/Stop Pin 9
CAS4 A16*2B Pin 9 - Start/Stop Pin 2