Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
SVCI 6154A - Good Clone?
27-06-2022, 08:57 AM,
Post: #31
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
|
|||
27-06-2022, 22:16 PM,
(This post was last modified: 27-06-2022, 22:38 PM by alexturbo.)
Post: #32
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
(27-06-2022, 08:57 AM)r0my81 Wrote:Standard free shipping actually no customs, DHL then already calculates(30-05-2022, 11:52 AM) rehatflogs Wrote: Hi has anyone tried the SVCI 6154A I want to contribute my test for SVCI 6154A: Tested with Odis 9.1.0 and Odis 14.1.0 both from this forum. Odis S and E recognize SVCI 6154A as VAS6154A without any problems, without additional setup, only loader is installed. Tested flashing on an Audi A6 4G 2017 engine control unit --> worked great --> duration of the flash approx. 3 min. WLAN also works perfectly. Problem: Communication loses again and again during diagnosis -> replacement for this, disconnect the head from the vehicle and insert it again, then it works again. Cause still unknown, the question would be whether other testers have the same problem, or is it my head or PC. Haven't tested it online yet, as soon as I'll test it I'll give you direct feedback. |
|||
28-06-2022, 07:52 AM,
Post: #33
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
I ordered Same from Flyobd.
|
|||
29-06-2022, 12:30 PM,
Post: #34
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
(27-06-2022, 22:16 PM)alexturbo Wrote:(27-06-2022, 08:57 AM)r0my81 Wrote:Standard free shipping actually no customs, DHL then already calculates(30-05-2022, 11:52 AM) rehatflogs Wrote: Hi has anyone tried the SVCI 6154A |
|||
29-06-2022, 20:48 PM,
Post: #35
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
@r0my81
Cable and wifi comes the problem. Also tested on different cars. |
|||
30-06-2022, 00:46 AM,
Post: #36
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
(29-06-2022, 20:48 PM)alexturbo Wrote: @r0my81 Not tested wifi at all. Not interested in using it anyway and causing additional risk when flashing! However Cable not caused issues so far. Constant connection no drop outs. Approx 40 mins session all online One thing to note if you plug cable in before running flyobd launcher, windows grabs the device and uses its network drivers. Launcher will then have no connection to the adaptor, no matter what you try. Best thing is to remove the windows device under network adaptors, disconnect cable, rerun launcher and then attach cable. When you hear a beep means all is connected fine. |
|||
06-07-2022, 16:55 PM,
Post: #37
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
The products of China's small workshops are very rubbish, have poor compatibility, switch between wired and wireless, often dropped, and the support for old models is very poor!
|
|||
07-07-2022, 00:45 AM,
(This post was last modified: 07-07-2022, 00:55 AM by rehatflogs.)
Post: #38
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
Don't disagree with your statement in general.
However been using this adaptor for a few weeks now offline and online and no issues experienced at all. Works smoothly just like the original 6154A with latest ODIS S and ODIS E. Support has been very active in responding to questions too on their whatsapp line. alexturbo Wrote: Wrote:@r0my81 If you are dropping connection go to services.msc on your laptop and check VAS6154A service is running. If not stop and start it again. This service syncs the adaptor to the 6154A driver, if this is not running, the adaptor will drop connection all the time. This service is a resource hog though, so my suggestion is to stop the service when you are not using the adaptor, and only run it when you need to use it. but this is not a must |
|||
07-07-2022, 05:40 AM,
Post: #39
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
@rehatflogs
I will check your advice next time. Otherwise break off communication happens more often lately. I noticed that the driver disappears in device manager. But otherwise the head works perfectly |
|||
08-07-2022, 18:04 PM,
Post: #40
|
|||
|
|||
RE: SVCI 6154A - Good Clone?
Have same problem with USB connection. Online function work fine.
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
2 Guest(s)
2 Guest(s)
Return to TopReturn to Content