[thecash]

Hi, i need some help flashing msv80 on the table with winkfp.

[koziol]

Im also interested how to do that

[emhtuning]

Get can bridge if you want simple achievement or can adapter to manually send wakeup signal to the dme . In general any ecu has can low / can high connectors and power connectors .

I do tons of flashing / coding on bench using can bridge.

[bawareca]

I have made myself female OBD connectors with pins to connect to the ECU and external power supply. AVDI has 120 ohm resistors built-in, other interfaces will need external resistors(if not pair, at least 1).
You can use the same connection diagram for MSV7x/8x and MSD8x.

[koziol]

Ok
so if I wona flash it on bench using K+DCAN device
what is procedure to connect 120ohm resistor
sorry for stupid question

[bawareca]

The resistor must be connected between CAN L and CAN H, preferably closer to the ECU end. Ideally 2 close to both ends.

[thecash]

Thank you bawareca,
all is working good i am able to program on the table with autohex2.
with winkfp i always get error messages , need help to program with winkfp.

thanks

[bawareca]

I have done many modules with Winkfp on the bench this way. Check your data and K+DCAN functionality.

[Deimis]

Please recommend a good can bridge to connect E and F series cic and nbt for flashing on a table.
Thanks