[Vin_Ka]

Maybe in your VO is a wrong entry read your VO with ncs expert ,you can edit your VO with ncs expert ,too

How can I see if there is a wrong entry? Should I just try to read all the available modules?

[yzc729]

WBAFB71020LX58560-VO

[Vin_Ka]

Ok today I checked al modules with ncsexpert to be sure all the numbers are equal.
I saw on a forum ON POST-02 cars you have to select any module with "A' in front of it and on PRE-02 the "A" modules wont work, you will need to use EWS or KMB.

My car is from 10-2005 but only the modules EWS, KMB and KMBI show up which sounds a bit weird to me while I just read these modules were used only in Pre-02 cars....

Anyway, I selected EWS to collect ZCS/FA from the ECU.

It gives me my

Bauhreihe: E53
GM: (not important)
SA: (not important)
VN: 0014037AF70

After I pressed back (F6) I selected SG Auslesen (F4) wich gave me a list of all modules. All the modules gave me VN: 0016437AF72 that is not corresponding with the VN I got earlier..

All modules were readable except the following 3:

ABG-Fehler bei ZCSUT Umrechnung.
COAPI-2020: SG antwortet nicht
IFH-0009: SG night angescholossen oder meldet sich nicht.

KMBI-Fehler in CABD! Siehe CABI.ERR und ERROR.LOG!
COAPI-2041: Falscher SG-Codierindex
A_KMB2: CODIERINDEX = 00h

RSMC- Fehler bei ZCSUT- umrechnung
COAPI-1043: Fehler bei CBD-Dateiverarbeitung
SMCDS_RE.C04

Can anybody make sence out of this?

[Vin_Ka]

@yzc729
I tried the VO you gave me with the following result:

1st it says " Vehicle order imported succesfully"

2nd "This vehicle order is invalid and cannot be imported ( invalid vehicle order elements ) Provide the correct vehicle order and import again.

I have no clue but it seems there is something structualy changed in my car. Do you have any idea perhaps?

[yzc729]

Your car is replace ECU the to be programmed? Maybe you can TeamViewer PM I, I can help solve.

[Vin_Ka]

Your car is replace ECU the to be programmed? Maybe you can TeamViewer PM I, I can help solve.

@yzc729

You got pm

[Alpina116]

VO from NCS expert (Enter ZCS ->ZCS/FA from Ecu-> Enter Vo/FA ->) now you see the VO/FA compare with the VO from VIN Decoder

[st3f40]

Hi all 

There is any way to create me new VO . Iwant to add this options 
S3AG
S508
S416
 My vin is A920668

Thanks