Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
ISTA/P
08-07-2017, 15:54 PM,
Post: #1
|
|||
|
|||
ISTA/P
Hello everyone,
Have a little issue need some help with. I was programming an e90 (12/05) with ISTA-P. Cas successfull. JBBE - error (Global.Vehicle.communication.CoAPI.2000) Ista stop the programming. I'm unable to connect to car with ista-d or inpa. Error from ista from pervious session - jbbe programing sport mode. Now car cluster needs will not work and I'm getting a sheering wheel lock error. Tools used. Original icom next a/b Can someone recommend anything? |
|||
08-07-2017, 16:08 PM,
(This post was last modified: 08-07-2017, 16:08 PM by bobdinro.)
Post: #2
|
|||
|
|||
RE: ISTA/P
If you connect the ICOM to your car dont have Ecu- s discovered?
You have a battery charger constant 14.0 volt? |
|||
08-07-2017, 16:19 PM,
Post: #3
|
|||
|
|||
RE: ISTA/P
(08-07-2017, 16:08 PM)bobdinro Wrote: If you connect the ICOM to your car dont have Ecu- s discovered? Hi, When I connect with ista I get unable to identify car. With INPA I Can only see jbbe and it say no service_error. Car is connectee with battery charger set to flash program with steady 14.1v. I tried to update the module with winfkp and received the following error no response. |
|||
08-07-2017, 16:35 PM,
Post: #4
|
|||
|
|||
RE: ISTA/P
(08-07-2017, 16:19 PM)Mizta Insane Wrote:(08-07-2017, 16:08 PM)bobdinro Wrote: If you connect the ICOM to your car dont have Ecu- s discovered? Try disconect battery for few ours and check again |
|||
08-07-2017, 16:53 PM,
(This post was last modified: 08-07-2017, 17:07 PM by bobdinro.)
Post: #5
|
|||
|
|||
RE: ISTA/P
You have ignition on in intrument cluster? kl 15, kl 30 14,1 volt?
Stop trying to flash! even if a flash fail you still must have ecus listed, RED, BLUE GREY or BROWN listed, you have to power the car ecus. JBE is faulty! |
|||
Reputation: +1 - Mizta Insane [+1] | |||
08-07-2017, 17:13 PM,
Post: #6
|
|||
|
|||
RE: ISTA/P
I got kl 15, 30 and 14v
I will replace jbbe and reply. I also did tried to disconnect and reconnect battery. |
|||
21-07-2017, 12:46 PM,
Post: #7
|
|||
|
|||
RE: ISTA/P
UPDATE: Replaced JBE was then able to complete programming.
|
|||
29-07-2017, 13:32 PM,
Post: #8
|
|||
|
|||
RE: ISTA/P
What is JBE. Thank.
|
|||
29-07-2017, 16:40 PM,
Post: #9
|
|||
|
|||
RE: ISTA/P
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content