[Gabriel130592]

Hi the virgin file is good it was read with x prog for that it has 2kb
this is aworkin immo off read with bdm (8kb) you need to reprograme the injecters codes use it with the mpc file i have send it
good luck

Hello! With your file the vehicle starts but the error codes appear:
P1603 ECU
P1351 Preheating Relay circuit

The injectors are encoded with Diagbox.

The car still does not exceed 3000rpm with these faults.

---

I've virginized the original file and coded the ECU with Diagbox and coded the injectors.
In the Eeprom 349 differences have been made but still giving the error code:
P1613 downloading

When you start the first time engine failure appears, and does not exceed 3000rpm.
You turn off the car, turn it back on and it works perfectly.
When you leave the car 20 mins off you start it and skip the fault again.

It is necessary to start, stop and start again to allow the car to go from 3000 rpm.

The eeprom is defective.

Attached file broken ORIGINAL (1)
I attached the VIRGINIZED file of this Eeprom (2)
I attach the file CODED with LEXIA (Replacement ECU and Inyectors) (3)

Any solution?

Greetings and thanks in advance.

Regards

[squadr33]

'these ecu's actually come with 2 different types op eeprom..95160 & 95640
even when all numbers match you can have different eeproms (found out myself sadly)
when you write full bdm backup from ecu with 95160 on a ecu fitted with 95640 it will never start.

i have full bdm files for both types, let me know wich you need