[gugu558]

I have all tools galletto kess etc.on bdm ecu connect but read empty file all mpc epr etc. when writing bdm or pinout at 100% file copied i have error.

[8baller]

How strange, killed ecu by reading

i thought the EDC16C9 was ID + write only with kess, EDC16C39 was partial data read

[Stiffmaster]

Clone warriors ...
Get ori full bdm and write it with good tool bdm

[8baller]

Clone warriors ...
Get ori full bdm and write it with good tool bdm

is that all of us? or just an assumption?

[benii75]

Ecu is not possible to be killed when you read the data that is very very dificull to explain ,but when is bad checksumed the ecu can be blocked and after can be recoverd by BDM i think from my experience

[Stiffmaster]

Clone warriors ...
Get ori full bdm and write it with good tool bdm

is that all of us? or just an assumption?

Just a joke
I started the same way, some years ago.
But I had too much problems, so I sold everything and bought genuine

[Remap Ross]

All it needs is volatage spike at right point then dead,,,but chances are 0.0001 %
also bad tools and bad cracked sw dont help as you have no back up apart from buy new ecu.
so remove ecu,,,send ecu pictures and we see if can help,maybe compononet damage inside...smd arent hard to fix. i have brought 98% of dead ecu brought to me back from DEAD

[betrescudan]

Disconect batterie for half hour
then try again to read by obd with power batterie charger

[Stiffmaster]

Not shure about Opel edc16. Maybe try writing over pinout on bench. Than you won‘t have voltage issues
But not shure if you need immo Signal for writing on bench

[gugu558]

Sorry the delay but this ecu just does not communicate with ktag and galletto. i managed to write int flash with ktag engine 1.7 cdti 101 hp.with 1.9 just did not want to communicate. i sent the ecu and the car is on the street.

thx all for opinion


by the way I got the original galletto and I did the job with ktag china clone