[Enabled]

Here we go. Got out the old soldering iron and removed the Samsung and installed my ISSI modules, before the 168hr is up





You know what they say about practice....


I like how this one turned out.

Soldering looks nice!!

Did you use drag solder method?

Yes, and lots of flux.
This time I used solder with some lead in it.


I also installed LT3010 and it is not good at all. It will make the tool not power on. Just 1 flash of the LED and off. I put the original chinese design voltage regulator and it worked again.

[ninja_zx11]

I also installed LT3010 and it is not good at all. It will make the tool not power on. Just 1 flash of the LED and off. I put the original chinese design voltage regulator and it worked again.

LT3010 from china or from Arrow? If its chinese then it could be fake.

[Enabled]

From China. So your result may vary

[mystic8v]

Hi does anyone have a link to buy the issi ram you guys have installed? Cheers

[leonfrrojito]

I sent a private message with the link to the store I hope you can serve and help a greeting

[Enabled]

It's not classified information


Yes, this ram is equivalent to the original unavailable ram.

[apoelistas]

I paid more more for 'questionable Samsung RAM' from ebay which came in a simple letter envelop without any anti-static packet.

I received the 4 samsung memory chips purchased from ebay.

Are these SAMSUNG memories original???
SAMSUNG 014
K6R4016C1D-UI10
TANE08ED KOREA

ALL 4 MEMORIES ARE THE SAME. Very similar to the one below
   

[Enabled]

I paid more more for 'questionable Samsung RAM' from ebay which came in a simple letter envelop without any anti-static packet.

I received the 2 samsung memory chips purchased from ebay.

Are these SAMSUNG memories original???
SAMSUNG 014
K6R4016C1D-UI10
TANEDBED KOREA

ALL 4 MEMORIES ARE THE SAME.

That memory works fine, but we can never really be certain they are original.

What got me a little skeptical was on the underside, in the recessed circles, it says TAIWAN. So which is it, Taiwan or Korea?

So that's when I decided to put the ISSI memory in, which is guaranteed genuine, even if it says Taiwan on it as well.... but at least the specifications are guaranteed.

That being said, I noticed no difference in how the VAS5054a runs with either. The tool works the same, as far as I can tell.

[apoelistas]

I also added a picture above and corrected to TANE08ED.
Yes you are right. I just observed that detail. It says Taiwan. I had to get a magnifying glass to read those small letters.

I am still waiting for the au and oki before making my vas5054a look at least original .

Cheers for the confirmation.

[Zocker010]

Can someone told me which Interface is the best to use it for ODIS-E 7.2.2 and have the best hardware. You can send me a PM with a link where i can buy a good interface