[spanaz1]

Hello Everyone,
I have a BMW F25 which cannot turn on terminal 15, The car was parked in the evening but when tried to start in the morning the car didn't respond to start button. I can diagnose all the modules when I keep the car awake by continually pressing the start button or turning hazards on. I tried to put the car on battery charge while diagnosis since the battery was discharged but that didn't help. The faults are in CAS, JBB And ZGM
CAS:930700 CAS under voltage, 93076B terminal 30B deactivation 
JBB; 8020E8 reset or deactivation of terminal 30f, C9140D No message (Terminals, 0x12F), Receiver JBE, Intermittent
ZGM; 801c60 ZGM no flexray initialization. 801C20 ZGM central fault memory full.
I tried reactivation the terminals, I've tried initialization for the flexray, I tried register the battery, I've checked the fuses and all the powers going to CAS. Now I don't know where to touch. Another thing, The owner said it once happened but after jump starting the car started. But this time even jumpstarting or connecting the car to charger for hrs the car refuse to turn on ignition. Anyone has idea or ever experienced this?

[piconerd]

Hello Everyone,
I have a BMW F25 which cannot turn on terminal 15, The car was parked in the evening but when tried to start in the morning the car didn't respond to start button. I can diagnose all the modules when I keep the car awake by continually pressing the start button or turning hazards on. I tried to put the car on battery charge while diagnosis since the battery was discharged but that didn't help. The faults are in CAS, JBB And ZGM
CAS:930700 CAS under voltage, 93076B terminal 30B deactivation 
JBB; 8020E8 reset or deactivation of terminal 30f, C9140D No message (Terminals, 0x12F), Receiver JBE, Intermittent
ZGM; 801c60 ZGM no flexray initialization. 801C20 ZGM central fault memory full.
I tried reactivation the terminals, I've tried initialization for the flexray, I tried register the battery, I've checked the fuses and all the powers going to CAS. Now I don't know where to touch. Another thing, The owner said it once happened but after jump starting the car started. But this time even jumpstarting or connecting the car to charger for hrs the car refuse to turn on ignition. Anyone has idea or ever experienced this?

Make sure battery voltage is good / charge the battery fully. Try Carry out 'CAS Reset' via scan tool / i5тд

[spanaz1]

Ok thanks, maybe I should just replace the battery because I tried to charge but nothing changed