[viki300]

Hi need to change new engine ecu for Opel Vectra C engine 2.8 OPC its B05cн ME9.6 ecu what tool i need, is gobaltis enought and openport inteface or do i need MDI and online connection i got орсом which works for immo ok but software i can not make it that  allready tryed one and write one ecu thrue obd with flex and its locked now

[schmidti]

bcz its a me9 i would prefer to look closer to cheap bdm100 and make full clone by bdm.

[viki300]

bcz its a me9 i would prefer to look closer to  cheap bdm100 and make full clone by bdm.

i would but ori ecu broken and its that ecu full of jelly and belive me its ME 9.6 tryed to read boot with flex and pogo pins never managed to read it the new one after it was locked 

opel me 9.6.rar
File Type:
Downloaded:	4 times
Size:	612.87 KB

[pupu144]

Should be enough with Glоbаlтї5 + Openport (or any compatible J2534 device).
Online is totally not necessary.
Need to perform IMMO procedures after programming the unit - for that орсом should cover it.

P.S. If I recall correctly, only 2005+ Vectras are supported for ecu reprogramming in Glоbаlтї5. Cannot check this info now.

[viki300]

ok then i try that all ready get immo ok with орсом but went a bit south after obd writing software well now i know another thing is to get Glоbаlтї5 working with win10 allready spend few days i can get it open but to communicate with tactrix is another thing

[pupu144]

Best to set up VM with Win 7 x86 and install Glоbаlтї5 and Tactrix drivers there.

[viki300]

thanks so i installed to fresh win7 x86 and now looks much better just need to try it to car as well

[viki300]

is there solution for this error E4403 using tactrix

[pupu144]

Post VIN and HW number please. I can build you an archive and you can try flashing with DP5 application.

[viki300]

VIN W0L0ZCF3571094550 and HW 55565197this is old ecu HW