Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
20-01-2016, 20:56 PM,
Post: #11
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
Yes guys it works. post closed problem solved
|
|||
20-01-2016, 21:23 PM,
Post: #12
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
Perfect, thank you
regards
|
|||
10-02-2016, 18:46 PM,
Post: #13
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
Its possible to use ICOM for F cars like "enet"? for INPA with Fxx data, or swid reader for fsc... ?
REMOTE and obd_625 i can use only on E cars, but its totaly nonsense, dcan cable do the work right.. but on F cars i hate connecting via ENET... zgw_search is trying to get me totaly crazy. ten or more (sometimes never) minutes before some ip of vehicle is show... ESYS with icom works well but it have own way to connect. |
|||
26-06-2018, 14:49 PM,
(This post was last modified: 26-06-2018, 15:05 PM by ka_rai.)
Post: #14
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
hi friends
i need your help no way to run ncespert with dcan cable or with icom A2 but if i run ista D or P , i can work no problem itool radar ok easyconnect : battery green / ignition red ===> so is problem ? INPA show bateri and ignition ON but i not see car list to choice my E70 (i think it strange no ? ) and no way to read chassis using ncsexper always error "faulty chassis" anybody can help please ? |
|||
26-06-2018, 16:22 PM,
Post: #15
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
Maybe Your INPA and NCS setup is incorrect?
|
|||
26-06-2018, 16:45 PM,
Post: #16
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
|
|||
26-06-2018, 17:30 PM,
Post: #17
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
Personally, I use DR.GINI to configure my ICOM.
Just hit interface and GINI will find any connected ICOM. Just select it, hit allocate, then hit connect. Just close out GINI when you're done. One program can detect the ICOM and read off the I.P., lock the ICOM, and configure your ediabas.ini. You still need to use easyconnect for stuff involving ICOM B and flashing on the MOST bus. |
|||
26-06-2018, 17:51 PM,
(This post was last modified: 26-06-2018, 18:56 PM by ka_rai.)
Post: #18
|
|||
|
|||
RE: Configure genuine ICOM to work with EDIABAS INPA NCSEXPERT
here my ediabass.ini from windows using DCAN cable
if anybody can check it , dcan cable port com1 dr gini link https://cartechnology.co.uk/showthread.php?tid=7023 thx |