[raffy haddad]

hello czozen
fem authorization with vvdi2 not good till now a lots of vvdi2 fem users having same issue and some not even work no new and old key they stop working
hope they fix it
regards

[krug]

Hi is  any1 successfully change  ISN  in  MSD81 with  vvdi2 ?

[chenjake]

Can I share a news here？Because I think it's a good news
The xhorse free token for vvdi mb and vvdi 96bit 48 clone!
Vaild---Feb 25,2019

[Impac]

Also interested if VVDI2 can Read and Write MSD80 and MSD81 ISN, seen couple of videos on youtube and vvdi2 gave an error VERSION NOT SUPPORTED

[strikeforce]

is VVDI2 j2534 pass-through working with techstream now?

[M83]

Hi

I have a question, with vvdi2 I can program ecu (EDC17C64) second hand in the seat leon III ?

[klisenko]

hello i have a situation with vvdi key tool i tried to clone a key from citroen c4 2006 
all steps go ok when i put the special transponder id 46 made by xhorse for cloning id 46 
screen show for the moment dont suport writing this transponder

[strikeforce]

hello i have a situation with vvdi key tool i tried to clone a key from citroen c4 2006 
all steps go ok when i put the special transponder id 46 made by xhorse for cloning id 46 
screen show for the moment dont suport writing this transponder

I Did actually clone a peugeot 407 successfully with VVDI key tool, perharps try using another transponder.

[Batje]

My experience for BMW on the latest firmware:
CAS1-OBD good
CAS2-OBD mostly good, had EWS tampering fault code with no-start once.. cleared with ISTA/D sync.
CAS3-OBD good
CAS3+(+)/encrypted /ista-p version-OBD very bad! downgrading bricked a few CAS modules -> much safer by soldering and making key from EEP dump.
CAS3+(+)/encrypted/ista-p version is very good if you do it via File make key. DO NOT write new EEP dump back, even if it tells you to. The key will work fine without writing back the modified dump and in fact writing the modified eeprom could brick your CAS in my experience.
CAS4(+) via soldering also very good and safe. you need good skills with hot air soldering and good flux.
FEM/BDC- only tried once on a bench setup.. worked fine with the test bench but never tried it on a real car.

What are most experiences with the FEM/BDC?
Problems with programming? Bricked FEM/BDC?
Keys not working? Original keys not working,....?

[dbsgh140205]

Hello I have a Problem with a BDC BMW after update and restore eeprom data, not work no communication, I dont remember if I mistake and use eeprom clamp with 12v connected if I do it what happen eeprom die or some other component, is reparable? how can test what happen? or maybe the programmer fail in update module for unlock, any help is appreciate thanks