[pankar]

Hello,
I try to program full dump to s3000 with Piasini 4.3.
I have read it, but I can' t write it. I have try with 680, 580, 480Ohm resistors.
Does anyone know why this happen.

[perso69]

You can make a try with FGtech V54, it work well too for S3000. If still error, it seem MCU came bad.

[araby80]

Put 470 ohm resistor....tested 1000000 times

[pankar]

I try with 470 Ohm but I can't write it yet. My solder it's ok.
To reprog s3000 should the coolant and the air temperature to be below from 50 Celsius.
For that we put a resistor. The one end from resistor goes to pin f4 - pin coolant temperature.
I try today with different resistors connected to pin f4 - f2 and another one for the air temperature.

[pankar]

I use different resistors .I try to connect to coolant temperature pins f4 -f2 whit 1k resistor and the air temperature pins e2 -e3 whit 1k but i have 't good luck.

[perso69]

I use different resistors .I try to connect to coolant temperature pins f4 -f2 whit 1k resistor and the air temperature pins e2 -e3 whit 1k but i have 't good luck.

Here you can try FGtech, i use alway for S3000. No any resistor, no problem

[pankar]

I've tried it like this but I couldn't' write it. Maybe the mcu has problem.

[perso69]

Yes this seem MCU came bad, you need change ECU, virgin eeprom, plug on car with ognition ON for 30 and start.

[dadal]

I use different resistors .I try to connect to coolant temperature pins f4 -f2 whit 1k resistor and the air temperature pins e2 -e3 whit 1k but i have 't good luck.

Here you can try FGtech, i use alway for S3000. No any resistor, no problem

finally was anybody able to write this ecu with Galetto V54 ?
I can read full flash but cant Write it back to ecu .. ( I'have used this same pinout )

[dadal]

I use different resistors .I try to connect to coolant temperature pins f4 -f2 whit 1k resistor and the air temperature pins e2 -e3 whit 1k but i have 't good luck.

Here you can try FGtech, i use alway for S3000. No any resistor, no problem

Hi Mate, do you ori galetto or clone ? I have clone v54 (Full reworked ) but I cant still write this ecu ( reading full flash No problem)