[hojo29]

Are the 3 ECU addresses still readable with Tool32?

[BimmerSLO]

No they are not

[osd]

On what address it failed exactly? 62 or 63?

63, but the main problem is, that there is no laser to be seen on the MOST

Program Gateway memory in programmer.

Thank you for the suggestion. Do you maybe have a backup of the Gateway memory?

[hojo29]

And what happens when the battery is disconnected?
Is then cic readable with Tool32?

[atomantmk]

And what happens when the battery is disconnected?
Is then cic readable with Tool32?

I think that you have erased FSC and certificates, I was trying to update car from my friend and same happens to me.
I'm waiting now on some good Samaritanian to send me fdc repair pack and to flash with ISTA/P and ICOM Next.

[BimmerSLO]

@hojo29: no, the cic is not readable. After I ran steuergaeret_reset in tool32, CICR.prg, the MOST bridge completely stopped working. I cannot even connect to CIC thru DCAN.

Now I replaced the CIC with another one, but will attempt to fix this one. Will keep you updated. Thank you @osd for the file

[ausanpe]

Hi i have the same problem my car is a e82 with cic and ista p aborted when programming 62 the status was 12 so i try to repair with winkfp i use some files i find in a post some failed now in ista d i have all cic in blue program aborted now winkfp dont want to do anything some ideas?

[hojo29]

If CIC is blue then you can usually save it again.
Important here is an ICOM.