[kemler94]

Hello @ all.

Somebody can help me, to remove this DTC from the .frf file in attachment?
This is EDC17CP44 ECU.

Important Notice:
DTC read with VCDS from Gears / clutch Control Unit , not from ECU!
This error came every 1-3 minutes.

8040 , P17D8 00 [044]

And sometimes this error too:
8031 , P1740 00 [038]

Maybe its possible to delete the temp sensor for clutch / gears?
Cause the car tells, clutch or gears are to hot.
Original message :"Torque Restriction due Clutch Temperature"
If you see the error by driving car, the engine / gears get in emergency mode. (no power anymore).

You do it not for free, i will pay for good solution.

Thanks a lot.

[Enabled]

For starters, disabling DTC reporting does not prevent limp mode.

[betrescudan]

read on boot mode actual dump of your ecu...then use this frf file to rewrite your ecu...test your car and see if have same errors...then use boot mode tool and read like .bin file...and post the dumps...actual dump and dump after writing frf...maybe your car have a bad remap inside