[blueman2]

I have this installed as guided in this thread. Running both programs in VMWare. All seems OK except it will not connect to my K-CAN USB. A few questions:

1) The networks connector in ICOM and ISTA VMs are both Custom (Vnet2). But when I look at properties, both are set to Vnet0. I tried resetting to Vnet2, but they keep going back to Vnet0. Is that OK?

2) I run the D-CAN version of ICOM VM snapshot, then the ISTA VM program. Does the order of starting matter?

3) I noticed that my USB D-CAN was connected to ISTA VM and not to ICOM VM. I tried disconnecting and reconnecting to ICOM VM but that did not help. But I assume D-CAN should be active on the ICOM VM, right? It shows up under Device manager as COM9, which I also assume is the correct port(?).

4) I noticed detailed process in a PDF to set up for D-CAN vs other interfaces. Do I need to do all those steps or have those already been done in the VMs included?

If anyone who has gotten this running with D-CAN can give advice, I would appreciate.