[beemerboy88]

Thanks beemerboy i've rechecked everything my vmnet2 was not checked to power on every works fine now, is there any settings i can change to make it run faster; im on a i7 4700 16gb ram alienware

Very fast cpus don't make that much of a difference (i5 will run it the same as i7).

But you can speed up the loading up of the vms alot by installing them on a ssd drive (snapshots will restore a lot faster). And because you have alot of ram you can change the VMware workstation memory settings via the main menu to speed it up a little (edit > preferences > memory > additional memory > fit all virtual machine memory into reserved host RAM).

Note: do not increase the actual ISTA vm memory settings above 4GB. 4GB is optimum.

But you cannot speed up the initial diagnosis/coding part much. ISTA/D/P are always slow when doing the initial vehicle check/scanning of modules. Especially slow when using a K+DCAN cable.

If using K+DCAN:

In the ICOM vm you can try changing the K+DCAN cable transmit/receive speed in advanced settings to 4096 (see pic below). Important: latency timer should be always set to 1 to avoid communication problems.