[sebastianfernandes]

As the title reads, I have 2 Icom's that need repair.
1 is ICOM A1
2 is ICOM A2
Both clones.
When plugged in all LED'S flash red and then nothing.
Cannot connect via ethernet, usb doesn't work for restore firmware.
Just Dead. Guess power supply issue.
Any one able to repair these?

Regards
Sebastian

[Deimis]

I also have a bad ICOM A1, cannot connect via ethernet, but usb restore firmware works.

Is it repairable?

[danyro]

mine was dead with no ethernet connection(link) and if I recall, with one green led on.
I've fixed it by replacing the bad NAND with a new one bought from HERE.
Afterwards performed the ICOM restore procedure and that was.
Maybe is worth trying this.

The hard part is to find someone with the right tool/s to replace the NAND(unsold/soldering).

@Deimis - yes, for sure it will work as it seem that you have my issue with bad NAND.

[DNK76]

In Poland there is a company that repairs,
diagnostic heads,
including ICOM A1 and A2 clone

[RocketSurgeon]

I was in the same boat with a non-working a1 and a2. The A1 wouldn't detect KL15, and the A2 would briefly flash all 4 red lights, then refuse to do anything. I noticed there were a few crooked chips on the A2 board, right between the multi-pin connector and the processor. I figured one of them went bad and got hot enough to melt the solder. I took those chips off my A1 and soldered them on my A2 to have 1 working ICOM. I'm so irritated with my clone, I'm just going to break down and buy a genuine ICOM NEXT.