Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Retrofit RearViewCAM issue on FEM
03-08-2018, 15:29 PM,
(This post was last modified: 03-08-2018, 15:31 PM by mdma666.)
Post: #1
|
|||
|
|||
Retrofit RearViewCAM issue on FEM
I installed and coded TRSVC on 2015 F82.
The TRSVC wont start up, no communication. Tested other TRSVC - the same. Check wiring and coding - all ok! It seems like the FEM wont activate the K-Can. I have a FEM ZB7 High but normally all FEMs are equipped with the K-Can Controller and it activates itself via coding any K-Can Client (TRSVC, RDC..) to make sure: - no wiring prob (CON 8 Pin51/52, 12v, Ground...) - no coding prob (3AG via FA coded in ALL ECUs) - checked K-Can wires with oszi; def. dead! - fault memory is empty instead of REM "missing qualifier RearCam" - I retrofitted the TRSVC about 50 times but never had a prob like that Any1 an idea how to activate the K-Can maybe with Tool32?!?!? |
|||
03-08-2018, 16:24 PM,
(This post was last modified: 03-08-2018, 16:33 PM by nesa.)
Post: #2
|
|||
|
|||
RE: Retrofit RearViewCAM issue on FEM
hi
Do you use Icam end did you connected to CAN3? |
|||
03-08-2018, 18:29 PM,
Post: #3
|
|||
|
|||
RE: Retrofit RearViewCAM issue on FEM
Put a 120 Ohm resistor between Can high and Can low. That will activate can line.
Coding E + F Modelles in near from Graz, Austria
Navigation map updates I-Step update CIC, NBT, NBT EVO Retrofit and remote coding |
|||
03-08-2018, 20:44 PM,
(This post was last modified: 03-08-2018, 20:46 PM by mdma666.)
Post: #4
|
|||
|
|||
RE: Retrofit RearViewCAM issue on FEM
(03-08-2018, 16:24 PM)nesa Wrote: hi TRSVC is not ICam (03-08-2018, 18:29 PM)BimmerSLO Wrote: Put a 120 Ohm resistor between Can high and Can low. That will activate can line. normaly the 120Ohm are inside the TRSVC. I also tried the 120OHm between High-Low yesterday but Nothing changed. Its possible that you have one TRSVC without the resistor but not three. I tried three different TRSVC Ecus |
|||
04-08-2018, 11:53 AM,
(This post was last modified: 04-08-2018, 15:21 PM by BugFix.)
Post: #5
|
|||
|
|||
RE: Retrofit RearViewCAM issue on FEM
check the wirring diagram
one a question ... did you install exactly the trsvc or icam ? |