[victorysatgr]

maybe you can read ecu via bdm... if you can get the files(eeprom flash micro) it's easy to clone the ecu...

try to find someone with ktag or galetto and try to read the ecu via BDM maybe it is possible....

check the possessor on your new ecu, is the same?

if you get the files copy that to new ecu and you are ok...

[Oddjobly]

from what i have researched it appears you still need to power the board which obviously cant really be done, what i want to know is does the eeprom chip just hold immobiliser info or does it hold the flash as well ?i am hoping to get them copied but everyone seems to have different opionions on this subject its getting confusing, lol!

[victorysatgr]

you have second ecu?

if yes, try to connect the broken ecu with power by solder wires on board to read it....

the "new" ecu can be done immo off need eeprom and flash... for the job...

[Oddjobly]

yes have new ecu also have pin card for same, have pin card for original, literally am only missing flash from old ecu cos i cant power it

[victorysatgr]

Find to your "new" ecu where pins of power and ground goes to pcb and try to solder cables to the edge of the broken pcb...

otherwise post dump of "new" ecu (flash & eeprom) to make immo off