[Black Alien]

hello friends

do we have a specific transponder for mazda 3/axela?
my client lost his key. I have Tango programmer to make a key by dump.

[raffy haddad]

tango will tell you what transponder type to use
usuallu original trans. is 4d.63
regards
did you find the eeprom on dash ?you idn't report back mate regards

p.s don't open 2 threads concerning 1 subject
read rules mate

also use magic buttons please
( thanks and reputation ) at least

[Black Alien]

yes
I have found the eeprom on the dash 93c56
and I used 4D60 to make a key..the car did not start.
Now i will use 4D63

Tango only said 4D type only that is why i got confused

[raffy haddad]

hello tango should make transponder id 63 after generate
strange
can you post eeprom dump to check ?
regards
p.s some mazda cars need to synchronise dash ecu
did tango generate new file ?
can you also post data of the transponder generated by tango ?
regards

[Black Alien]

here is the file created by tango after making a new key
I have uploaded it in the eeprom but I have not test the vehicle yet. The owner is out a bit

[raffy haddad]

something wrong with file
in original file how many keys are used ?
in this dump that you post is it read as 8 or 16 bit ?
post original dump and the transponder data original
and the transponder made by tango
your file seems not good
regards

[Black Alien]

this is the main file..
original file...
i once erased the lost registered key because it failed to add a new key

so here is the dump read from eeprom the very first day

---

and now I have made a key using 4D 63 after the first file did not start the engine


here is the key data below

---

i havent tried this new file yet. if there is something wrong with the file then I may beg you friends to share a working one that I can use to make a new key

[raffy haddad]

hello no need to beg
Thats why this familly is intented to help each other
please read the original key and the key made by tango by key reader
and post here
might your new transponder wrong
Your main file compared to other not contain any key data so it must be manipulated or wrong read
If the dash is with you read eeprom as 8 and 16 bit
regards
P.s please post all i asked you so i can help you in a good way

[Black Alien]

well..
is there is any eeprom original data for mazda 3? I can write it back in the eeprom and read it again to make a new key with TAngo and post new key data generated by my Tango

---

is this file correct?
Can I use it to make a key?

[Black Alien]

my main file got no key..I erased the keys when I tried to program the key on board using x 1oo. the when I noticed a failure to add a key, i suggested to remove eeprom and make key by dump using Tango