[muhammed78540]

Hi I have a question
My friend has an E87 118D from March 2006, and he installed new Bi-Xenon headlights he had the halogen, however there are just the angel eyes that light up it would have to code the famous code SA 522 with NSC EXPERT for them to work? 

If you can help me

[bmw320d]

yes to need code 522 write fa to cas and frm, then code frm ecu, you need install right cable for pin bi-xenon signal in frm ecu

[haty]

you need to add pin #2 and bridge it with pin #4 on the headlight connector ...(brown GND wire)

[muhammed78540]

[quote = "bmw320d" pid = '443860' dateline = '1556741379']
yes to need code 522 write fa to cas and frm, then code frm ecu, you need install right cable for pin bi-xenon signal in frm ecu
[/citation]

http://nutsofamily.com/wp-content/upload...NGE-VO.pdf

I have to make a link with FA 522. Is this true?

---

[quote = "haty" pid = '443865' dateline = '1556743924']
you need to add pin #2 and bridge it with pin #4 on the headlight connector ...(brown GND wire)
[/citation]

just coding is not enough? or send us the coding and connection with the wires

[dumitru.o]

you need to replace also frm

[Freddy1]

So you didn´t do the wiring, just installed the headlights? You need to make a few changes, also you could attach the bi-xenon pins to high-beam pins and code it right, then you can use the bi-xenon without changing the frm

[Semi14]

Hello

They are all almost the same in the Halogen Lamp as well as in the Xenon lamp. For Xenon you need to add the Two Weights in the Left Lamp - Pin 2 and 4 to Point X165 and the Right Lamp Pin 2 and 4 to X166. You can make a bridge between 2 and 4 and combine them simultaneously

Additionally, you must add Pin 5 from the Left and Right Lamps to the  PIN 41 (X14260) in FRM module. The pins should be bridged.

After this operation, add $ 522 to the equipment.

You do not need to change the FRM module unless you want to add height sensors, then you need to change the module to the FRM XE

Greetings

[muhammed78540]

Thanks, I'll try to do the wiring like you told me.