Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Solved ✔ VTG coding incorrect error
07-07-2019, 00:55 AM,
(This post was last modified: 07-07-2019, 22:22 PM by Clusters.)
Post: #1
|
|||
|
|||
VTG coding incorrect error
Looking for help/guidance with resolving an issue.
I updated VSGG83 ECU on E83 using WinKFP and K-DCAN, now I am seeing ABS, Brake and 4x4 lights on dashboard. Car drives fine. ISTA+ says there is a coding error so I installed ISTA-P 3.66.1 with 6.1F loader with hope to do the coding there. Unfortunately I can't seem to connect even with ICOM emulator activated. Thoughts: - INPA doesn't have a job list option for E83 so I don't have the list of modules. I picked the highest ZB-Number 7599883 to flash in WinKFP, could that be an issue or would any ZB-Number work? I assumed higher is better. - In ISTA-P Loader I went through installing patched EDIABAS 7.3 + run K-DCAN network config tool. Still no connection with K-DCAN cable. - VTG module status in INPA+ sometimes shows module grey, sometimes orange. Doing ECU tests tells me ECU is working properly. What do you recommend I do next? Some screenshots attached. |
|||
07-07-2019, 01:33 AM,
Post: #2
|
|||
|
|||
RE: VTG coding incorrect error
Perform coding via NCSexpert
|
|||
07-07-2019, 22:19 PM,
Post: #3
|
|||
|
|||
RE: VTG coding incorrect error
Thank you jaramillo. Everything is good now.
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content