[willisodhiambo]

post your eeprom dump i will set it to 0

 Do that, I can also help. Had this problem previously and support could not help. Used other tools.

[Hoborg]

Hello,

Autohex has a problem with that, I had it too.

Use a better tool, then it will work.

thx

What device do you mean besides good known explorer ?

[chang2]

Hello,

Autohex has a problem with that, I had it too.

Use a better tool, then it will work.

thx

What device do you mean besides good known explorer ?

hello,

i used bmw exploter, works fine.

[Hoborg]

This I know , I asked about other tools than explorer. Besides last Year I had one case where Explorer didn't do MEVD17.2 properly, so it's not that perfect either.

[Santa Cruz]

post your eeprom dump i will set it to 0

Hello,

Can you please do working hours set to 0 on 95640 dump from attachment ?

Thank you in advance.

[PDXAutoworks]

post your eeprom dump i will set it to 0

Hello,

Can you please do working hours set to 0 on 95640 dump from attachment ?

Thank you in advance.

Working hours cleared.

[bm92]

you can use vvdiprog to read d-flash, reset eeprom working hours to zero, use e-sys and default code all ECU's with original FA

[MTKAutoHex]

Hello colleagues,

I have problem with DME F07 N55 2010.
After unlocking CAS via OBD with BIMMER TOOL (to make a new key). DME error "1f2108 dme incorrect data record variant monitoring". The car can start, but it's sluggish. I did the below but the problem is still not resolved.
1. Change DME working hours to 0 using autohex.
2. Replace other CAS.
3. Clone DME, CAS from 1 similar car F07.
4. Coding FDL power class DME, CAS.
Any help is appreciated, willing to pay if someone comes up with a decent solution.
Thank you.

can you send your D-flash to our support team