[Mshumacher]

Hello someone know why on bikes, my ista dont show terminal 15?
Read vin correct, read modules, but cant perform any actions like clear errors or any activations/ learning any component...

I tried ENET cable and DCAN on bmw bike adventure 850gs, both the same...

Maybe i should try J2534 or there is some trick or modify cable or something for the terminal 15 to appear correctly ?

Thank you

[Vojno]

Hello someone know why on bikes, my ista dont show terminal 15?
Read vin correct, read modules, but cant perform any actions like clear errors or any activations/ learning any component...

I tried ENET cable and DCAN on bmw bike adventure 850gs, both the same...

Maybe i should try J2534 or there is some trick or  modify cable  or something for the terminal 15 to appear correctly ?

Thank you

Neither ENET nor D-CAN measure the KL15 voltage!!!
D-CAN also only detects, but does not measure!

[ReW]

If the motorcycle of 2021 (2022 model range) is S1000RR, then it can be read ISTA, but ABL will not be available without ICOM, right?

And in order to see the programming ista motorrad, you need to add the string SWIDataUX and the version to the registry.

[piteerus]

hi there,
installed ista+4.31.40 everything works as expected (connection wise) it reads vin and diagnostic ok. but some menus are greyed out on vehicle management, notably the product structure and I cannot access to some functionalities of the bike, like retrofits...

I am missing files?

I got similar problem. I have icom clone, ISTA+ v4.41 and I'm able to connect to my bike S1000XR 2018. But can't code, retrofit, adapt ECUs, use convertsions. ISTA reports ICOM bad connection. Did you solve the problem?

[Vojno]

hi there,
installed ista+4.31.40 everything works as expected (connection wise) it reads vin and diagnostic ok. but some menus are greyed out on vehicle management, notably the product structure and I cannot access to some functionalities of the bike, like retrofits...

I am missing files?

I got similar problem. I have icom clone, ISTA+ v4.41 and I'm able to connect to my bike S1000XR 2018. But can't code, retrofit, adapt ECUs, use convertsions. ISTA reports ICOM bad connection. Did you solve the problem?

If you have ICOM, I can make it remote!