[Olgierdo83]

Hello


I have a problem with a galaxy mk2 1.8tdci 100ps. The car runs very badly, smokes, has no power. Injectors checked, timing checked, compression checked, turbo checked - preventively regenerated.
After starting, the car behaves as if it were burning the DPF, the speed is 950, the fan is on 1st gear, it heats the rear window - not always. When accelerating, it smokes black very much (this car never had dpf). The ECU was replaced (I think, described with a felt-tip pen).
Can someone confirm the correctness of the installed ECU using the VIN number?
This is how PCMFLASH identifies it:


Interface: Scanmatik - SM2 USB
DLL: 1.0.0.15 (built 12.02.19)
Firmware: FW:0808 HW:02 SN:A55259
Protocol: Ford Mondeo 4: 1.8L Lynx, 2.0L DW10C STAGE 4 (SID206)
Identification
VIN: WF0MXXGBWM8C24912
SW Version: 7G91-12K532-MG         
Serial number: 000285107758   
Part Number: 7G91-12A650-RG         
Hardware: 6G91-12B684-DA         
Calibration file: 10139621AA      10139643AA      10121708AA      7G91-14C275-AA 
CVN: CB6B4DC6-334A82AD
Completed


Below is the flash read from this ECU.

Could someone put the original (correct) flash for this car?

greetings and thank you very much.

[lsalt100]

Hello


I have a problem with a galaxy mk2 1.8tdci 100ps. The car runs very badly, smokes, has no power. Injectors checked, timing checked, compression checked, turbo checked - preventively regenerated.
After starting, the car behaves as if it were burning the DPF, the speed is 950, the fan is on 1st gear, it heats the rear window - not always. When accelerating, it smokes black very much (this car never had dpf). The ECU was replaced (I think, described with a felt-tip pen).
Can someone confirm the correctness of the installed ECU using the VIN number?
This is how PCMFLASH identifies it:


Interface: Scanmatik - SM2 USB
DLL: 1.0.0.15 (built 12.02.19)
Firmware: FW:0808 HW:02 SN:A55259
Protocol: Ford Mondeo 4: 1.8L Lynx, 2.0L DW10C STAGE 4 (SID206)
Identification
VIN: WF0MXXGBWM8C24912
SW Version: 7G91-12K532-MG         
Serial number: 000285107758   
Part Number: 7G91-12A650-RG         
Hardware: 6G91-12B684-DA         
Calibration file: 10139621AA      10139643AA      10121708AA      7G91-14C275-AA 
CVN: CB6B4DC6-334A82AD
Completed


Below is the flash read from this ECU.

Could someone put the original (correct) flash for this car?

greetings and thank you very much.

hi didn't check the file. Think only about IAT... is it right measured? because of the rear window(also higher rew)..... lower temperatures - needs more fuel.

[Olgierdo83]

Hello, iat I think like good, rear window are heating without driver request (like a DPF procedure) at idle, the car smokes gray, the smell is not burnt diesel (similar to kerosene)