Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
E39 535i 1999 automatic to manual
09-12-2022, 18:51 PM,
Post: #1
|
|||
|
|||
E39 535i 1999 automatic to manual
Hello.
Does that swap need clutch pressing switch? When I change DME software from auto to manua car wont start anymore. I coded EWS park/neutral to nicht active. So, should start, but nothing happend. |
|||
09-12-2022, 23:34 PM,
Post: #2
|
|||
|
|||
RE: E39 535i 1999 automatic to manual
(09-12-2022, 18:51 PM)Duken Wrote: Hello. did you adjust the vehicle order and unplug the automatic transmission? |
|||
10-12-2022, 00:04 AM,
Post: #3
|
|||
|
|||
RE: E39 535i 1999 automatic to manual
you still need a signal for clutch switch for EWS3.
|
|||
10-12-2022, 09:04 AM,
(This post was last modified: 10-12-2022, 09:06 AM by Duken.)
Post: #4
|
|||
|
|||
RE: E39 535i 1999 automatic to manual
(09-12-2022, 23:34 PM)AZCKNCLLC Wrote:(09-12-2022, 18:51 PM)Duken Wrote: Hello. VO is not touched. And TCU is disconnected (10-12-2022, 00:04 AM)bmchicago Wrote: you still need a signal for clutch switch for EWS3. Can I disable that singnal from EWS? |
|||
10-12-2022, 17:44 PM,
Post: #5
|
|||
|
|||
RE: E39 535i 1999 automatic to manual
(10-12-2022, 09:04 AM)Duken Wrote:(09-12-2022, 23:34 PM)AZCKNCLLC Wrote:(09-12-2022, 18:51 PM)Duken Wrote: Hello. Code ews to manual with ncs dummy, or manual vo. |
|||
10-12-2022, 17:55 PM,
Post: #6
|
|||
|
|||
RE: E39 535i 1999 automatic to manual
the ecu for the AT should be connected and only need to code the EWS. and the car will start. then you should find the correct SW for the engine ecu(MT).
No help for people not give a feedback
|
|||
10-12-2022, 18:36 PM,
(This post was last modified: 10-12-2022, 18:38 PM by Duken.)
Post: #7
|
|||
|
|||
RE: E39 535i 1999 automatic to manual
(10-12-2022, 17:44 PM)Qwerti Wrote:(10-12-2022, 09:04 AM)Duken Wrote:(09-12-2022, 23:34 PM)AZCKNCLLC Wrote:(09-12-2022, 18:51 PM)Duken Wrote: Hello. If some one have manual EWS FSW_PSW dump that would help a lot (10-12-2022, 17:55 PM)loki954 Wrote: the ecu for the AT should be connected and only need to code the EWS. and the car will start. then you should find the correct SW for the engine ecu(MT). I found manual software number from realoem.com but not sure is it right for this car |
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content