[blax123]

Hello Guys,
i got a BMW E64 Covertible with Roll over Controller Error "93FE", which means that the Controller is not installed, which however is installed. I can check the Part Number in INPA as well. Coding is perfectly fine, so its a Module error.

Someone got a fix for this?

Readout in the attachment

Chip: ST 95080.
Partnumber: 6577 6950640; HW: 9 SW: 17

[mo328i]

Hi,

I am actually facing the same problem with an e64. replaced the ABG module and getting the same error.

in particular, the car fits ACSM60 if that helps.

Any workarounds?

Thanks

[dragon100]

No problem ... fixed ... sometimes need change eeprom and write fixed file again ...

[mo328i]

Thank you for this.

First, how do I program with this file? I mean what SW am I suppose to use and what process?

Then, the file needs a password to unnzip?

Thanks!

[dragon100]

Desolder eeprom 95080 and read, upload file here ...best way use original file ...

[mo328i]

Desolder eeprom 95080 and read, upload file here ...best way use original file ...

Thanks for the response. I have some questions though since I haven't done this before.

Am I suppose to read the EEPROM from the ROC module? and then I have only Xprog, is this SW suitable for the task? Then, is it mandatory to desolder the SoC, or I can do it with the SoC soldered?

Finally, if I replace the ROC unit with a new one (assuming that the fault is stored there - otherwise please advise) will I get rid of the error?

Thanks!

[mo328i]

Hi,

Ok so I managed to read the .bin file, from the ROC 95080 with the fault 93FE.

Could you please send me the cleaned file (+password)?

Thanks in advance!!

[dragon100]

Your fixed file ...

[tonemoz]

Hi, same problem! 

65 77 6 950 640
HW9 SW17

File attached.

Any help greatly appreciated

[dragon100]

Your fixed file ...