[BS68]

Hi friendsI

I changed the pump of an A4 B6 2.5 tdi 2004 to a compatible pump with the engine code label. 


Extract pin code from dash (RB4) for encoder with vcds. When i go to (Login-11) to write the pin obtained "by adding a 0 in front of the numbers" i get an error asking me to cut the contact and wait... Then it's the same thing over and over again. 

The pin obtained by dash is: 1754 

Reading with X431 gives me: 00787 both don't work. 


I saw a pin on the seller's label, it says: 41603 This one is accepted by (Login-11) but then when i go to (Adaptation) there is an error (a lot of request request) and does not work. 

I do not know how to do ? If a boss could direct me please i would be very grateful. 

PS: I had performed the same procedure on A4 B7 2.5 was ok without problem. 

Thanks in advance.

[BS68]

Dear friends

Would it be possible to power off the ecu in order to start the vehicle ?

Any suggestions are welcome, i'm a little lost.

Thank you.

[elektronik13]

Dear friends

Would it be possible to power off the ecu in order to start the vehicle ?

Any suggestions are welcome, i'm a little lost.

Thank you.

read and put the flash and eeprom of the ecu here

[amor89]

hi perform an immo off on ecu edc15 its working 100%

[BS68]

Dear friends

Would it be possible to power off the ecu in order to start the vehicle ?

Any suggestions are welcome, i'm a little lost.

Thank you.

read and put the flash and eeprom of the ecu here

---

Thank you friends for your help, I extracted the flash in direct brochange with ECU and eeprom read by obd.

I wanted to do an immo off but winols gives me an error to set the checksum, please help me with the off flash + eeprom + checksum, I won't forget your help, thank you in advance, at your service .