[Powerlab]

Or check out bmw explorer “red dot” solution on their website with supported swfl’s works great when putting brand new st 35160wt in cluster with erased mileage ofcourse.

yes, it is a perfect function, it helped a lot

[RuleNormaliai]

the best tool for 35160 and 35128 is CGPRO at the moment, sometimes it takes more time to erase it, but for two years working with it never had a single chip that it would not succeed with.

[fitacuevas]

I use VVDI Prog and vvdi chip 35160DW. it is simple and effective.
read original chip and write to vvdi chip. solder and done.

[Adekborys69]

the best tool for 35160 and 35128 is CGPRO at the moment, sometimes it takes more time to erase it, but for two years working with it never had a single chip that it would not succeed with.

Bought cgpro few weeks ago , and tried 160wt and 128wt and none of them are working for me cant erase mileage on them , any solution? Already tried at least 3 different chips and no one been cracked…

[maksymw]

35160WT and 35128WT are erase well by CGPRO, but when erasing the waveform, you need to heat the eeprom, e.g. with hot air, every few seconds to a fairly high temperature and observe how much progress in procent has gone forward. A tested method Sometimes deleting a large mileage takes up to 30 minutes Be patient. If you don't believe it, try it.

If you erase 35128/35160 in cgpro with hot air, you must auth. to the program settings using the password " cgkj982634187236 "

[RuleNormaliai]

CGPRO works 100%, but it needs alot of patience, for example today i worked ~2hrs to erase 35160WT, it often fails, but it works in several tries, didn't have even one chip with which i couldn't succeed, no need to heat chip with high temperature, it is enough 100-120c, you heat it for a minute, remove air gun, after few minutes heat again, when you see percents rising, remove air gun, if it stops, heat it again.

also, as maksymw said, you have to initialize your device with that password, but not every time, if you see that it fails erasing few times, you initialize it and try again.

It is not rocket science, but common sense is required.

[Adekborys69]

I have hot air even one time I was trying to heat chip but without success but didn’t know that need to initialise my tool with password , will give it a go then , thanks guys !

[SweetBMW]

Why is the init required?

[maksymw]

I don't know why it requires initialization, but I know that's the only way it works.

   

[Adekborys69]

thanks guys finally it worked for me , but have another question , got cluster (not cleared by me) after coding showing 999999mls and dot , chip is m35128wt but is clear , got ory standard cluster and want to put correct mileage to it but always when try to write mode 1 or 2 its showing that cluster have more than 800.000 k and erease is not posibble , but firts two lines are FF .. any solution how to disable erease check in the software of how to manually write first two lines? tried vvdi prog but without suscess thanks


Update to solve issue with this CG support only solution is to replace chip