Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
X3 n46 can’t bleed air of cooling system
22-04-2023, 21:51 PM,
Post: #1
|
|||
|
|||
X3 n46 can’t bleed air of cooling system
X3 n46 can’t bleed air of cooling system
Already changed pump, thermostat, radiator but no luck upper hose is always empty full of air |
|||
23-04-2023, 02:25 AM,
Post: #2
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
|
|||
23-04-2023, 07:05 AM,
Post: #3
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
Use vacuum for bleeding.
|
|||
23-04-2023, 15:17 PM,
(This post was last modified: 23-04-2023, 15:19 PM by bosna1973.)
Post: #4
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
(23-04-2023, 02:25 AM)2013m5 Wrote:(22-04-2023, 21:51 PM)bosna1973 Wrote: X3 n46 can’t bleed air of cooling system I can’t find in ista any instructions plus n46 have mechanical pump behind power steering pump which spinning water pump (23-04-2023, 07:05 AM)Volum Wrote: Use vacuum for bleeding. It didn’t help or mechanic didn’t do right job |
|||
23-04-2023, 17:06 PM,
Post: #5
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
1. Basically you fill it up with the bleeding screws open, then close the screws but leave the cap off.
2. Start the engine and wait until you see coolant coming out of the small hose at the top of the reservoir, then close the cap. 3. Leave the engine idle for a while, wait for it to cool down, and top off. You want the thermostat to open so make sure it reaches operating temperature.Be prepared to top it off a few times as needed. |
|||
23-04-2023, 18:13 PM,
Post: #6
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
(23-04-2023, 17:06 PM)2013m5 Wrote: 1. Basically you fill it up with the bleeding screws open, then close the screws but leave the cap off. That is what i did but can’t get water flow from expansion reservoar if I don’t press pedal and get around 2k rpm |
|||
24-04-2023, 04:46 AM,
Post: #7
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
Filling possible only after vacuum bleeding
|
|||
24-04-2023, 07:32 AM,
Post: #8
|
|||
|
|||
RE: X3 n46 can’t bleed air of cooling system
And why did you change pump thermostat etc?
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content