Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Solved ✔ A4 RB4 DASH PROBLEM
09-12-2023, 21:49 PM,
Post: #1
|
|||
|
|||
A4 RB4 DASH PROBLEM
hi, i have a A4 with dash Bosch RB4 with error:
01128 - Immobilizer Pickup Coil (D2) 35-00 anyone know how to repair dash? i have measure wire from antena to dash and is good regards PS: to drive car i make immo off but get 2 problem, climatronic dont work and the hazard lights switch on. i need to repair dash or disbale haards and put climatronic work thanks |
|||
10-12-2023, 08:05 AM,
Post: #2
|
|||
|
|||
RE: A4 RB4 DASH PROBLEM
With eeprom dump from ECU, you can make a new transponder with iprog if you have it, then adapt new transponder with vcds using the pin number from the car and everything will go back to normal, you can get a transponder on the bay for around 5 euro
|
|||
Reputation: +1 - dabaca [+1] | |||
10-12-2023, 09:18 AM,
Post: #3
|
|||
|
|||
RE: A4 RB4 DASH PROBLEM
from ross tech :
01128 - Immobilizer Pickup Coil (D2) Possible Symptoms Immobilizer Warning Light flashing Immobilizer active (Engine shuts OFF after 2-3 Seconds) Possible Causes Wiring and/or Connector(s) from/to Immobilizer Pickup Coil (D2) faulty Immobilizer Pickup Coil (D2) faulty Immobilzier Control Module faulty Possible Solutions Check Wiring and/or Connector(s) from/to Immobilizer Pickup Coil (D2) Check/Replace Immobilizer Pickup Coil (D2) Check Measuring Value Blocks (MVB) Special Notes Pickup Coils for Immobilizer 2 and 3 Systems should read ~ 18 to 24 Ω |
|||
10-12-2023, 15:48 PM,
Post: #4
|
|||
|
|||
RE: A4 RB4 DASH PROBLEM
hi, the problem is that dash, i cant make transponder because dash have a problem that i need to fix, coil is good, wiring too, problem is inside dash, i try change elmos inside dash but same problem, i dont know what are driver responsable for coil read
regards |
|||
10-12-2023, 18:29 PM,
Post: #5
|
|||
|
|||
RE: A4 RB4 DASH PROBLEM
can you read the cluster dump ? put it here .
or try to adapt another cluster |
|||
10-12-2023, 20:56 PM,
Post: #6
|
|||
|
|||
RE: A4 RB4 DASH PROBLEM
(10-12-2023, 08:05 AM)al70 Wrote: With eeprom dump from ECU, you can make a new transponder with iprog if you have it, then adapt new transponder with vcds using the pin number from the car and everything will go back to normal, you can get a transponder on the bay for around 5 euro (10-12-2023, 18:29 PM)mishuthebest Wrote: can you read the cluster dump ? put it here . hi, i cant find other dash, need to repair this one i know pin of dash, keya are ok, only dash gives error of coil |