[Simple]

This morning I operated DiagBox v7.76 with the network connected to the internet and noticed a message stating that DiagBox v7.xx will be unusable after 16 October 2015, and that I will have to install DVD 8 (DiagBox 8.xx)... Read the message on top of the "Home" and "Measurements" tabs in the first picture.

Well, to verify this news I turned DiagBox off, advanced the date on my computer to October 20th 2015 and sure enough, my previously working installation gave me the error "The communication card is incorrectly initialized. The tool must be restarted". Tried a couple of times, but to no avail..

With the date still advanced, I turned off DiagBox, disconnected the network then turned DiagBox on again, and it worked. See attached photos.

The moral of the story, to avoid errors, keep your network cable/card disconnected. In fact DiagBox seem to respond faster with network disconnected.

Tests were performed on:
Notebook: HP Envy M6, CPU: intel i5, Ram: 8 GB, Hard Drive: 1 TB SSHD, Operating System: Windows 10 64bit running VMware Workstation 12 on which DiagBox 7.76 is installed on Windows 10 32bit / 4 GB RAM / 40 GB Drive Virtual Machine.

[Simple]

Yesterday I upgraded my Windows 7 based DiagBox v7.66 installation to 7.77 online. I did NOT receive the warning message that the DiagBox 7.xx installation will become inoperable after the 16 October 2015 and that I will have to install version 8.xx.

Initial conclusion is that this message may be relevant to the Windows 10 installations only...