Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
E39: LCM change vin tool32 ?
30-03-2018, 16:42 PM,
Post: #1
|
|||
|
|||
E39: LCM change vin tool32 ?
On a '97 E39 the lcm has been replaced. It now needs a correction on the vin and mileage.
Is this possible with tool32? I don't have BMW Scanner and not planning to buy it for 1 time use. Is it possible to connect the lcm on the bench? MGU virgin and patching in Europa.
Secure coding 2.0 Feature installer codes |
|||
30-03-2018, 18:41 PM,
Post: #2
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
It might be possible but for how long it would take to find out I would just spend the $8.50 on BMW Scanner.
Oh and you can connect to it on the bench but you need the dash to act as a gateway/protocol converter |
|||
31-03-2018, 07:07 AM,
Post: #3
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
For the lcm and cluster I only need to connect + and - and a wire which connects to the cluster?
How do I connect both to the obd port? MGU virgin and patching in Europa.
Secure coding 2.0 Feature installer codes |
|||
31-03-2018, 10:21 AM,
(This post was last modified: 31-03-2018, 13:58 PM by E60.)
Post: #4
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
You need to connect + and - from cluster and lcm. If you use High cluster, then connect cluster K-line to obd pin 7. LCM i-bus take from cluster.
|
|||
31-03-2018, 14:28 PM,
(This post was last modified: 31-03-2018, 14:30 PM by Vojno.)
Post: #5
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
If you want to connect on bench, you can only connect for LCM if you have OBD interface!
Because you can switch the normal OBD interface to K-BUS interface. On the obd.ini you must change "MODE=NORMAL to MODE=KBUS"! Than you can connect the OBD interface direct to LCM, pin 7 to K-bus pin in LCM. But how to edit the VIN and the odo i have no idea. |
|||
01-04-2018, 21:10 PM,
Post: #6
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
I'm using a can bridge interface.
Is obd.ini for a specific interface? MGU virgin and patching in Europa.
Secure coding 2.0 Feature installer codes |
|||
02-04-2018, 11:32 AM,
Post: #7
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
Is it possible to program the eeprom of the lcm? I do have a R270.
MGU virgin and patching in Europa.
Secure coding 2.0 Feature installer codes |
|||
06-04-2018, 15:25 PM,
Post: #8
|
|||
|
|||
RE: E39: LCM change vin tool32 ?
software BMW Scanner.
|
|||
« Next Oldest | Next Newest »
|
Users browsing this thread:
1 Guest(s)
1 Guest(s)
Return to TopReturn to Content