[Gecco]

Hello Guys,
view years ago a bought this interface, and with my own fault it was bricked after a FW update (wrong FW usage). Now after years, i have an ST-Link V2 Programmer and i am able to communicate with ST Link utillities to the STM32F407 chip on it.

I tried to flash and it was successfull but still no function. I think i do not have the right flash files for this interface and missing bootlоаdёя.....

My questions are:
1. Who can supply me the relevant files (BOOTlоаdёя & FIRMWARE) to re-animate this interface?
2. Is it in general possible over ST-Link V2 Programmer ?
3. What should i do as steps in ST-LINK Utillities ?

I also figure out that the J3 Connector with 8 Pins has following connections: Top left to to right > VSS > SWDIO > CWCLK > VDD
Low left to right > VDD > NC > NC > VSS

їшяgёs in attachment...

Thank you all in advance
Kind Regards Gecco

[dom92]

hello did you find a solution? because I have a VAS6154 with firmware 1.6.6 and I would like to upgrade it to 1.8.9. but with VXDIAG software it is impossible.

Thanks