[TurboDriver]

Hi all,

6WA won't sync with evo id5, language always English, units won't change. Previously had NBT didn't have this problem. I've coded EINHEITEN master to hmi but that's only allow changing units on EVO not Kombi, tried change KOMBI_CIC to kombi mid same result. Kombi was updated with V60 so don't think software level is an issue. What else it could be?

[acitric]

Hi all,

6WA won't sync with evo id5, language always English, units won't change. Previously had NBT didn't have this problem. I've coded EINHEITEN master to hmi but that's only allow changing units on EVO not Kombi, also coded KOMBI_CIC to kombi mid. Time is syncin and servicing, just language and units won't. Kombi was updated with V60 so don't think software level is an issue. What else it could be?

Hello did you try to change gateway table ?

Отправлено с моего SM-G930F через Tapatalk

[bmwcoder75]

Just VO code the unit and all will be fine, assuming you adjusted the FA if that was required.
There is no need to change gateway table.
As long as fibre optic is connected cluster and HU should communicate fine

[TurboDriver]

It's VO coded. I had NBT fitted before upgrading to id5, it worked fine with NBT