[Mario68]

I'm confused.
Which do you think is good and which is shit?

Your Opcom with a white PCB (Belarusian) should be of good quality with a real PIC 18F458 (Opcom New). For the second, I have two interfaces with a similar PCB and they are good quality with a real PIC 18F458. Take a look at your PIC on the green PCB. It has the inscription PIC 18LF458. It is probably fake.

[vdgle]

Thanks for your answer.
Unfortunately, with either version, I can't read any live data ( measuring blocks) on any vehicles after 2012.
This is normal for all clone opcom versions?
Or should I look for a better clone?

[mattydr67]

First of all you have to upgrade and then downgrade the firmware of your interface.
Do this operation once or twice.
Then test the interface. If you still connect to the car and it is not blocked then you have a good clone.
Do this test using OCFlash or even OP-COM software to upgrade ( only ) the firmware.
In OP-COM softwares you can see live data no problems. Well in some of them there are bugs , in others the crack used generate bad live data.
But not in all as you said.
Let us know the result of upgrade/downgrade the firmware.
Good luck

[vdgle]

I try with diferent opcom device, this time the firmware is 1.67.
This is working better but in AstraK 2014 in live data appear this in screenshot below.
This is normal for car after 2017?
Has anyone tested a similar car?

[Baki]

IF MY INTERFACE IS ORIGINAL HOW TO UPGRADE IT TO THE BEST VERSION. AND WHICH IS THE BEST VERSION FOR YOU,WHICH VERSION WOULD YOU RECOMMEND

[Mario68]

IF MY INTERFACE IS ORIGINAL HOW TO UPGRADE IT TO THE BEST VERSION. AND WHICH IS THE BEST VERSION FOR YOU,WHICH VERSION WOULD YOU RECOMMEND

Your interface looks like a good old Opcom V5.

Just use the Opcom 181022a (Fantomels) software and your FW will be automatically changed to the last real version 1.67.
But if I am not mistaken your current FW is Chinese 1.95. Then you would have to use OCFlash.

[Dartagnan88]

is anyone able to install these programs?
i have installed but all are asking to be activated. anyone available to assist for donation?

[Mario68]

is anyone able to install these programs?
i have installed but all are asking to be activated. anyone available to assist for donation?

Remove the latest drivers and then install those that are in the Opcom root folder. With this driver, SW does not ask for activation.

Please read the manual carefully.

[Zenix]

Did i tryed today opcom 200603a Prof and asked for an activation...i cant use it on car...
Need to activate, it give me also an hardware id...

EDIT: Did i see now need to instal driver from root folder and will no ask for any activation...THX

[MiKu]

I have op-com (clone) purchased in 2014 with PIC18F458 and FT232RL. What can the latest software handle?

From what I remember it was sold with V1.45.