[hugo325]

Ok, no worries for the manual, it is already well detailed

Hum I have another question about the TRSVC module location.
You suggest to put the module on the left trunk like this:


In the instruction document, he places the module near the driver's seat.
If we put the module in the trunk what will the wiring look like? Because there will not be enough cable length to go to the FEM module ?

---

I have another question about the signals: K_CAN_High and K_CAN_Low.
I need to connect them to the FEM module (passenger side).

I made a retrofit of the I-drive controller.
The old I-drive controller was in K_CAN1, I think... The new one is in K_CAN2.

Do you think I can connect directly to this connection ? Or do I have to go to the FEM module ?