[MichaelNRW]

Hi there,

i tried to code the shift lights because my car doesn´t had them enabled.
They are displayed in the iDrive settings for the HUD but never appeared.
I tried some settings around the M view and M menu but that caused some dead ends in the iDrive.
I removed the coding and only left this two values active:

Code:

CB_SHIFTLIGHTS => aktiv
HMI_SHIFTLIGHTS_HUD_ENABLE => aktiv

After that i had a CEL with some DTC related to the communication between the DKOMBI4 and other ECUs.
Now the HUD wont show the Driving Assistant or navigation information anymore.
I can see the speed and ACC.
DA should normally show two lines around the ACC info and a arrow when using the lane change assistant, these graphics are gone.
And the HUD doesn´t display the navigation info anymore.

Does someone had issues like this before?

I already got two tips i would like to test out tomorrow.
1. Check the VO and code the DKOMBI4 using the VO the car came with.
As i retrofitted some of the missing features like the iDrive touch controller and the touchless tailgate operation my current VO is modified.
2. Initialize the FlexRay.
I tried to find more information around this and found some threads about problems after doing this. They had to open the FlexRay ports with Tool32... is this even possible for the G series?

kind regards
Michael