[MichaelNRW]

Here are the DTC after rebooting or coding the DKOMBI4.

Code:

VIN: WBA6N11

Timestamp: 07/04/2023 14:18:18 (Local Time)
DTC Count: 15

ECU: KOMBSP18 - Instrument cluster
E10603 -> Instrument panel: Ethernet: Reset of communication


ECU: BDC_G05 - Body Domain Controller
D915C0 -> No message (status display, assistance system, 0x1C0), receiver BDC-ZGM, transmitter KOMBI / SAS
D91728 -> No message (relative time, 0x328), receiver BDC central gateway module, transmitter instrument cluster


ECU: SRR01_HR - Rear radar sensor near range right
CB1505 -> Signal (assistance system display status, 0x1C0) invalid, transmitter KOMBI
CB1448 -> Message (relative time BN2020, 0x328) missing, receiver HRSNR, transmitter KOMBI
CB1502 -> No message (status, assistance system display, 0x1C0), receiver HRSNR, transmitter KOMBI


ECU: LMV_G11 - Transfer box
CF5561 -> Signal (ambient temperature, 252.1.4) invalid, transmitter KOMBI


ECU: SGE48V - Starter motor generator 48 volt
DE5407 -> No message (relative time,BN2020 0x328), receiver SGR48, transmitter instrument cluster


ECU: VIP_G05 - Virtual integration system
D75506 -> No message (status display KOMBI, 97.0.2), receiver VIP, transmitter instrument cluster


ECU: DME8FF_R - Digital Motor Electronics
CDA728 -> No message (KOMBI status display, 0x1B3), receiver DME, transmitter KOMBI
CDC152 -> Message (Kilometerstand_2, 0x333) missing, receiver DME, transmitter instrument cluster
CDA71E -> Message (relative time BN2020, 0x328) missing, receiver DME, transmitter instrument cluster
CDA037 -> No message (units BN2020, 252.0.4), receiver DME, transmitter KOMBI
1B9804 -> Information engine switch-off time, signal: Missing


ECU: SAS_G05 - Optional equipment system
D1D47D -> Signal (data function of alertness assistant, 251.3.8) invalid, transmitter ACSM

Someone already offered me to solve this remotely but i would like to learn how to solve it instead of someone else doing it.

There´s no FlexRay error so that shouldn´t be the problem?
Is it normal that so many DTC come up after coding or rebooting the DKOMBI4? I can´t remember that from the past.