[Bavrian]

1710594802[/url]']

1710593806[/url]']

1710589174[/url]']

1710588453[/url]']
Ok got it working

so iv connected the pins in 1-2 in con 9 and as a test and removed the existing wires in those slots and the camera shows up under esys and works on idrive sceeen

So seems a ethernet switch is needed unless anyone has a work around this

---

The

1710588437[/url]']
Hello, you code ACSM?
O retrofited same ICAM in f44 and no problem, code 3AG in BDC HU and ACSM.
Car dont have ethernet switch.

Yes acsm was coded

Did your car have MGU or entrynav2 

As all ethernet slots on bdc are taken up on pin 1-2 & 37-38

Have MGU unit. But no switch.

I have noticed many installs have all been on cars with MGU mainly 

Similar to g30 they always had free port locations on cars with evo & mgu

---

1710592368[/url]']
First - there is a service function in ISTA to open connected ethernet ports. You don't tell us if you performed it (or corresponding job with tool32). If port was NOT used before it is CLOSED.

Second - you CAN'T connect multiple ethernet devices to the same port. If ALL ports on BDC are already used, you SHALL need the switch.

The ista job was carried out before trying the above pin change that made it work 
Yes all ports are occupied 

Seems the answer is a ethernet switch

if 1+2 or 19+20 or 37+38 is allready in use, than you have to install ethernet swith and connect kafas with icam to swith. yesterday i have install ICAM with swith in F40.


you have to buy 
61 35 5A0A438
61 13 9368538
and look for connector in air: A376*1B and 2x A376*2B

Thanks 

yes all 3 of these are occupied will look at getting the switch & parts