[aknight720]

Hey, thanks for you reply... that was one of the first things i tried but there isnt anything at that port. I'm going to try a port scanner but there is no info on the DoIP web interface either which is why i am a little stuck. The DoIP interface is just a generic Linux interface where you can update the system Rom/firmware and as far as i can tell its not like the other firmware versions i have found. Itool radar says firmware is revision 1000 (assuming that means 1.0). But have no idea if it always says that or if its accurate. May just be my luck i bought the one dud one on the market. Would buy a genuine one but its a one off diy job so doubt i will be using it again.

Are you 100% sure you are connecting to the ICOM IP address? Your screendump would suggest a router IP.

EDIT: Can this screendump be the vxdiag web interface? Anyone know?

EDIT2: @mace0 I am 98% sure what you have there is an Allscanner VXDIAG VCX NET. Check out http://www.vxdiag.net/?lang=en, download VX Manager and run VCXDoIP Update, that should detect the device and prove my theory.