[dncomputech]

Welcome everyone. Update is how to activate HBA with the switch off switch. Thanks for the NCD TokenMaster comparison tool
Who can help me?
I Have Coding VO FRM, FLA3 after adding 5AC.
Conclude.
Only works very well after Coding times. It turns itself off when the engine turns on the next time, I also switch the A-Off - A light switch, it doesn't work again.
Note: I choose FDL FRM, do not edit the code (FDL after having 5AC), and HBA works again,
I decided to run the test to see if it worked. As a result, it works very well, turns itself on and off high beams according to traffic, but when it stops and starts again, it disappears.
I have read somewhere on forums of HBA activation commands
1. / FRM >> FLA_VERBAUT = aktiv
2. / FRM >> FLA_AUTO_AKTIV = automatisch
3. / KAFAS2 >> 3050 >> FLA_ON_OFF = aktiv
But I equipped the mirror in FLA3 so I couldn't find it
KAFAS2 >> 3050 >> FLA_ON_OFF = aktiv, and I also rummaged in FLA3 nor did FLA_ON_OFF or it changed to another code?
I also searched in FRM the following code
a. / 3000 FRM_VERBAU_U_ALLGEMEIN, 20
LIN_PUBU_TLC
nicht_aktiv (not active) = 00

Comment = BEFAS: Auswertung des Tasters TLC (Time To Line Crossing / Fahrspruverlassenswarnung) am Bedienteil Fahrerassistenzfunktionen

b / / 3050 FRM_AUSSENLICHT_PARAMETER, 30
FLA_TASTER_LIN
ueber_can = 00
Comment = 0 - FLA Taster Information wird über CAN-Bus eingelesen: SZL ---> FRM
1 - FLA Taster Information wird über LIN-Bus eingelesen: BEL -> FRM "
OPTIONS
  ueber_can = 00
  ueber_lin = 01
c. / FLA_BEL_POS
stufe_A = 01
Comment = 0: FLA will be activated if BEL is in POSITION AUTO or MANUAL LOW BEAM;
1: FLA will be activated if BEL is in POSITION AUTO
Blendfrei nur in A, da auch nur hier die AHL funktioniert
OPTIONS
  stufe_A_und_II = 00
  stufe_A = 01
But I'm not sure these commands can automatically HBA.
Does anyone know please show me
Thank you very much