Unfortunately we do not accept new members for free, Now Registration cost 30€, if you are interesting Send Email to [email protected]
Flashing ZBE in Esys gives Error
|
26-08-2023, 01:46 AM,
Post: #1
|
|||
|
|||
|
Flashing ZBE in Esys gives Error
I try to flash my ZBE3 with Esys and it gives me som errors, see screenshot, i have also attached my FA File, SVT_Soll and Tal file if anyone want to check if there are some problems.
I-Step shipment is F010-12-07-533 and I-Step Target is F10-22-11-510 and I-Step current is F10-21-03-520 This is a bench setup with a NBT, ZBE3 and a ZGW 02 8SK My car is a 2011 F11 530D with all the modules upgraded to I-Step level F10-22-11-510 (Used to be F010-10-09-510, which was the car Shipment level) The plan is to Put the NBT, ZBE3 and the ZGW 02 8sk along with a ICM 2 module. But before i put these modules into the car i want them all on the same I-Step level as the I-Step level in my car. btw, is it possible to copy the txt in the logfile inside the E-sys flashing page? as it would be better than to take a screenshot. |
