[al70]

What tool you used by obd?

Svci, abrites, it probably works, I really didn't know how to use the tool, I jumped into the car and I didn't have a clue what I was doing, hence the dead cluster

[al70]

Ok guys, i give up on this cluster, always get security access error, I've ruined the micronas now, is there any way I can adapt the matching numbers cluster that I have ? Cheers

---

I don't have the pin from the doner cluster

[evg_eni]

adapt online in this case...

[al70]

what's the procedure evg-eni, i guess i'm going to need a vas interface and odis ?

[evg_eni]

Yes, if you can read new dash fl+eep and have tools maybee you will have another options..

[al70]

i will try to read the doner dash tomorrow evg-eni and get back, been at it for 12 hours today, if i stare at the wall, i can see the connections LOL

[Nkhchyk]

U can not adapt USED cluster online without old one - new only ( this is info what i got).
To restore immo - needed.
CS, MAC and power class and still need to read write micronas

Did U use connection posted? - it 100% working. But i used xprog6.12- more opportunetly - wiring not proper connected - U need to check it and lift -0 ohm resistor and 1 leg of crystal.
If micronas not damaged - u have to read it

[____ANGEL___]

xprog 6.12 works, 5.55 never worked in anything.

[al70]

i can't read it now nkhchyk, i destroyed it, in the end, out of frustration, i removed the micronas with hot air and tried to read of the board, disaster of course, yes i followed the connection, removed, 0ohm resister, lifted crystal, it could be a bad tool, whatever, i guess im fooked then

---

xprog 6.12 works, 5.55 never worked in anything.

can i update ? i can take pics of xprog pcb

[evg_eni]

Restoring immo without dash is possible, not easy but possible with tools. This thread have full potential to reach 10 pages now i bet this will end with immo off