[Cro]

its because the nbtevo with id4 screen and apix1 shows the same symptoms
many of us offer it if you want to end your problems

[Gatsby79]

i know that id4 screen cause issue on newest evo firmware.. until people sell id4 monitor as gold most of us will use id3 screen.. and nobody share solution for these old headunit.. we're talking of id4 and id5... is not id8.5..

[Cro]

delete this post

[vipsha]

I bought an ID4 Evo and an NBT ID3 screen after seeing this post and the author's solution. Is there a fully functional solution for an ID4 in an ID6 with an ID3 screen?

---

if you don't want issue on display stay on 18-03

Tell me more. What problems remain? Navigation is hidden from the menu.
Attempts to trigger a black screen are unsuccessful. When opening the car, you may see the message "No signal," but you must open the door quickly to get to this.
It's been 24 hours now and I haven't noticed any issues. I'm using  id3 screen, which is what this theme is for.

you can flash the latest ilevel, but you will have intermittent black screen issues which will be fїжed by a headunit reboot, however there is a permanent solution for this that can be implemented to fїж this and enable the screen to function normally

Do you know where to find a complete solution for id4 to id6 (23-07+) with nbt id3 screen?

[Cro]

need a voltage converter and a binary fїж
some of us offer this 5ёяvїcё

[vipsha]

Is it possible to create a bin file for a USB flash drive with the nbt reboot command?

[vipsha]

I found a solution. Simply connect the monitor's power and ground to a different location. For example, to the pins in the A42 connector. The head unit will not power the monitor and will not check for voltage or amperage changes.

[ruben_17non]

I found a solution. Simply connect the monitor's power and ground to a different location. For example, to the pins in the A42 connector. The head unit will not power the monitor and will not check for voltage or amperage changes.

Thanks for the solution!
I will try put converter inside evo unit.

The only question is this will not drain battery with car parked?

[vipsha]

I found a solution. Simply connect the monitor's power and ground to a different location. For example, to the pins in the A42 connector. The head unit will not power the monitor and will not check for voltage or amperage changes.

Thanks for the solution!
I will try put converter inside evo unit.

The only question is this will not drain battery with car parked?

Unfortunately, there's nothing to say thank you for. Today, the client called and said the monitor had turned off again. I lost the battle with the monitor.

---

I see one solution here. It's a script on a flash drive that will reboot the head unit. I'm asking for help, can anyone create a script for a USB flash drive?

[Airbus]

I am little bit confused.
When I use a NBTevo ID4+ Screen from F20 - without Touch - I dont need to add a voltage converter or change anything cause normally - even it is a apix1 screen - no errors should appear at all...

Right??!?!