[Reshi]

I can fix it but afcourse need needle

It needs calibration alot of work 1-2 hours

Better buy another dash

[johnc]

Where can i find info for the solder points on the rear of the board ?

for this type plus others ?

any info will be helpful, thanks !

[Dash_Burner]

Xmodder, I always remove the needles (where is possible) and always I remove the eep too, solder to r/w (not using clips) ( from 1998) and never had problems like this

If you removed needle WITH the metalic brooch in it you have to seperate metalic brooch from needle. Then put brooch in motor give power to dash and at last put needle in the right position. The best way is to fill up the car with gasoline put dash in the car (without needle but with the brooch IN the motor). Then put the needle to the full position. Also DESOLDER eeprom and rewrite with a new ori bin file.

[eliaselias]

Where can i find info for the solder points on the rear of the board ?

for this type plus others ?

any info will be helpful, thanks !

this is the rear solder point... i have test it with carprog and it;s work ok .
i have send you the color of cable with number of pin ..
if you need any more help you can ask

IF I HELP PLEASE HIT REP + THANKS

[johnc]

Thank you for that information , i was actually looking for the 2014 honda accord dash rear solder points , i taught it would be the same. but it is not , is there any info you have that can help me . thank you !

[eliaselias]

Can you send me a picture for the back of the dash