[Batje]

Hi,

can someone help me? I have a CIC here which was activated (it wasn´t me) with script. I am not able to remove the scipt.

The CIC was with last software C1A ...I flashed 63,62,A0 with winkpf but the script is already running. I have no option to connect via FTP because I have not the "right" USB-Ethernet-Adaptor. I tried with with one from lenovo (USB3.0) without success (I know the IP adress of my CIC). Also did all settings on my laptop to have the same pool and subnet.

So is there no easier way? No script to deactivite like the one to acitvate?

Every CIC has ethernet pins on the quadlock connector.
If the CIC is a retrofit, check if the ethernet pins are connected to the OBD connector(DLC). If not, run those wires and connect them up to DLC.

Then you should be able to use a standard ENET cable to connect to your CIC via FTP.
When connecting via ENET, set your computer to obtain an ip from DHCP (which there isn't so it will get a self-assigned address just like the CIC).

If you're not sure what IP the CIC is on, install and run Wireshark.
Let it sniff for a few minutes after you connect the ENET cable to the OBD port.
Look for Gratious ARP packets with a source address in this form: HARMAN/x_xx.xx.xx. In it's info there will be: gratious ARP packet from 169.254.xxx.xxx, and that's the ip of your CIC.

Oh and if you're ftp'ing into the CIC, make sure the client is set to Binary Mode otherwise there may be some translation errors between the cic and the computer.

As for how to remove the script, i have no idea how that's done but i would like to know that too.
I've never used script activation because in my opinion it's a really bad way to activate the FSC's in the headunit.
In fact it doesn't activate anything, it just creates a blank fsc set every time the device boots which will only work one time as long as the device doesn't reboot hence why it needs to run on every boot. Or so is my understanding of it so somebody correct me if i'm wrong